Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation.  Fits All Honda Talon models Receives a 2” Hitch Tube
Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation. Fits All Honda Talon models Receives a 2” Hitch Tube
Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation.  Fits All Honda Talon models Receives a 2” Hitch Tube
Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation.  Fits All Honda Talon models Receives a 2” Hitch Tube
Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation.  Fits All Honda Talon models Receives a 2” Hitch Tube
Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. Powder coated to protect from rust and corrosion. Easy installation.  Fits All Honda Talon models Receives a 2” Hitch Tube

Honda Talon Hitch Receiver Plate

CA-119-BL

Regular price $149.95
/
Shipping calculated at checkout.
  • In stock, ready to ship
  • ORDER NOW

> Fits ALL Honda Talon Models

> Receives a 2" Hitch Tube

> Fits with OEM Bumper

> Fits with Dirt Road Fabrication Spare Tire Carrier

Now you can pull your trailer or attach hitch accessories to bring all your gear along with you on your next ride! The Honda Talon Hitch Receiver Plate is made from ¼” inch Laser Quality HRPO Steel and receives a 2” hitch tube. The fully welded bracing design gives it the strength to take a beating over and over. To keep the Honda Talon Hitch Receiver Plate looking good, it has been powder coated to protect from rust and corrosion.


Installation is easy! Remove the 4 bolts from rear center holding the radius rods in place. Next, place the Honda Talon Hitch Receiver Plate in front of all four rods. Then using the same bolts, put them through the pre-drilled holes in the plate through the radius rods and tighten to 80 ft. lbs. - Incase the stock bolts are too short, use the 4 bolts, washers and nuts included in the set. 


Made in USA



This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

This is a Sample Product Title
Was $200.00 Now $100.00

You may also like


Recently viewed